Carlbosson
Posts: 6
Joined: Fri Oct 04, 2019 9:35 am

user defined macros

Wed Dec 04, 2019 3:53 pm

How do you set the "User defined Macros" on the machine control page? I would like to set one the drop the Z by 50mm then center the nozzle. In this case x=150mm and Y=150mm.
I would like to set another to enter the M916 command to start after a power loss.

Thank you in advance for all your help.

Carl

S3D-Chris
Posts: 173
Joined: Wed Jun 20, 2018 12:52 pm

Re: user defined macros

Wed Dec 04, 2019 4:20 pm

You can set the macros by going to tools > firmware configuration > macros tab

Carlbosson
Posts: 6
Joined: Fri Oct 04, 2019 9:35 am

Re: user defined macros

Fri Dec 06, 2019 8:03 am

Thank you

Return to “General Discussion and Tips”