Carlbosson
Posts: 6
Joined: Fri Oct 04, 2019 9:35 am

user defined macros

Wed Dec 04, 2019 3:53 pm

How do you set the "User defined Macros" on the machine control page? I would like to set one the drop the Z by 50mm then center the nozzle. In this case x=150mm and Y=150mm.
I would like to set another to enter the M916 command to start after a power loss.

Thank you in advance for all your help.

Carl

S3D-Chris
Posts: 175
Joined: Wed Jun 20, 2018 12:52 pm

Re: user defined macros

Wed Dec 04, 2019 4:20 pm

You can set the macros by going to tools > firmware configuration > macros tab

Carlbosson
Posts: 6
Joined: Fri Oct 04, 2019 9:35 am

Re: user defined macros

Fri Dec 06, 2019 8:03 am

Thank you

Hairig
Posts: 1
Joined: Fri Dec 06, 2019 6:07 am

Re: user defined macros

Sat Dec 07, 2019 11:51 am

Is that all the macros functionality there is, Chris? Or are there some hidden functionality too?

S3D-Chris
Posts: 175
Joined: Wed Jun 20, 2018 12:52 pm

Re: user defined macros

Mon Dec 09, 2019 1:34 pm

Hairig wrote: Is that all the macros functionality there is, Chris? Or are there some hidden functionality too?
The Macros tab contains everything we have currently. If you have ideas for additional options you would like to see please let us know by submitting a feature request!

Return to “General Discussion and Tips”