Hello
So i just bought S3D got i recommended from TH3D and a few youtube videos, on my Ender 3 it prints super good.
Then onto my Anycubic Kossel Linear Plus, gives me nothing but trouble, i have tried S3D's profile, and a few i have found online, they all do the same with some odd extrusion on the end of the layer, if you use Cura or Prusa Slicer this does not happen, it does not happen in "vase mode" on S3D but normal prints it happens.
Simplify3D on the left and Prusa Slicer on the right same retractions\speeds, also Extrusion Mulitplier is calibrated so it prints at 0.4mm
https://gyazo.com/de91a1e6e6af0853edc4428bbba3bf1f
