Simplify3D User Forum

Posted: **Fri Jan 03, 2020 8:07 pm**

As you can see in the attached image S3D is only slicing the supports, not the model. I know the model works fine as I sliced it previously with Cura and printed it perfectly. I've only seen this in this model so far, what the heck is going on?

Posted: **Mon Jan 06, 2020 9:53 am**

Could you please contact us at [email protected] and send a Factory File so we can look into this further for you?

Simplify3D User Forum

Only creating supports, not actual model

Only creating supports, not actual model

Re: Only creating supports, not actual model