Simplify3D User Forum

Posted: **Fri Feb 07, 2020 8:32 pm**

So I printed a cube and the walls are so thin that there are holes in them. I have attached a pic. What could be causing this? Not enough material being extruded? Should I change the multiplier?

Posted: **Tue Feb 11, 2020 8:49 am**

Could you please post a Factory File so we can look into this a bit further? Are you currently printing with only one perimeter?

Simplify3D User Forum

Print issue...walls of print too thin.

Print issue...walls of print too thin.

Re: Print issue...walls of print too thin.