Multiple parts print - bad 1st layer dierction on support
Posted: Thu Feb 20, 2020 7:27 am
Hello,
I think, this is a bug.
When multiple objects need supports, then the 1st layer over it has various directions. Why?
One of the directions is bad (marked by red arrow), because it is parallel with support.
Why Simplify3D changes 1st layer's direction in every object?. I have v. 4.1.2. and orig. Prusa i3MK2.
Is there a possibility to have JUST ONE DIRECTION for the 1st layer for ALL OBJECTS (the best is the right angle of course)?
Thanks for help
I think, this is a bug.
When multiple objects need supports, then the 1st layer over it has various directions. Why?
One of the directions is bad (marked by red arrow), because it is parallel with support.
Why Simplify3D changes 1st layer's direction in every object?. I have v. 4.1.2. and orig. Prusa i3MK2.
Is there a possibility to have JUST ONE DIRECTION for the 1st layer for ALL OBJECTS (the best is the right angle of course)?
Thanks for help