Simplify3D User Forum

Hi, I am having a few issues with the prime pillar in S3D. A few improvements I would like to see are:

- Choosing the coordinates of the prime pillar (e.g. pick x, y values instead of north, south, etc).
- Choosing the orientation of the prime pillar.
- Stop the prime pillar after the last layer of support.

Not having these features (especially the first one) regularly causes issues with fitting large prints onto the print bed. If you could fix this it would be much appreciated.

Best regards,

Conor.

Thanks for your request! points one and three have been requested many times before. Can you please clarify what you mean by prime pillar orientation being something you can change? Would this be the same request as being able to choose different shapes or even use your own model for priming?