Wipe Speed
Posted: Sat Apr 04, 2020 11:24 pm
Hi folks,
I'm tuning my prints and noticed that im getting slight blobbing artefacts from the wipe feature. When the hotend performs the wipe it is doing so at a slower rate than my standard printing speed. So slow that during that time it is re-melting the plastic underneath slightly which is causing it to widen slightly and causing the blobs.
How in S3D can I configure the wipe speed? I like the feature but ideally I want the wipe speed to always be the same as my print speed.
Thank you.
I'm tuning my prints and noticed that im getting slight blobbing artefacts from the wipe feature. When the hotend performs the wipe it is doing so at a slower rate than my standard printing speed. So slow that during that time it is re-melting the plastic underneath slightly which is causing it to widen slightly and causing the blobs.
How in S3D can I configure the wipe speed? I like the feature but ideally I want the wipe speed to always be the same as my print speed.
Thank you.