Simplify3D User Forum

I created a stack of face shields and want to create a separate profile for each part because I want to control the first layer speed for each part. I did this but the speed does not adjust it runs each first layer at the 60mm/s which is my print speed setting. I just want to adjust the beginning layer not the rest of the layers. Please advise...

If you are stacking face shields vertically and want the first layer of the each individual shield to be slowed I would recommend using the Variable Settings Wizard. We have a great article that covers this so I included the link below.

https://www.simplify3d.com/support/arti ... f-a-model/

Good read.