Simplify3D User Forum

I have the S3D Profile loaded.

I might be missing something but.. Where is the configuration for Dual Extrusion? Multi Color Prints?

I have to print this multi color:--
From the build plate up to 100 mm white
from 100 mm too 200 mm Red
From 200 mm too 300 mm Red

How would i configure this Artemis dual extrusion to do this print ?

Thanks

I think your first step would be to do some reading:
https://www.simplify3d.com/support/arti ... extruders/

You could also watch a video:
https://www.simplify3d.com/support/vide ... on-wizard/