Page 1 of 1
Overlapping extrusions
Posted: Mon May 18, 2020 6:10 pm
by nicholasav
Hello, can anyone help me identify the setting I need to change to keep things from overlapping like in the attached photo?
Re: Overlapping extrusions
Posted: Tue May 19, 2020 4:31 pm
by nicholasav
Perimeter overlap under thin wall behavior. Makes sense.
Re: Overlapping extrusions
Posted: Wed May 20, 2020 3:41 am
by Telson
Try setting your Perimeters to 3 instead of 4, that should fit.
Re: Overlapping extrusions
Posted: Wed May 20, 2020 5:16 am
by dkightley
The clue is in the question....."overlap".
There are two settings with the word "overlap" in their description. Perhaps changing one of them may be the answer! One on the Infill tab, one on the Advanced tab.