Dual Extruder Not Printing Support
Posted: Fri Jun 05, 2020 1:46 am
Hello! I don't know where else to go, I've looked everyone and checked FAQ.
I have a Tenlog TL-D3 Pro and I'm having the following issues.
The skirt and the brim print without issues using the 2nd extruder, but when it comes to printing the support. The extruder is floating in the air.
I've tried using Cura and Simplify3D and can't print the support.
Anyone know what the issue is?
Thank you!
I have a Tenlog TL-D3 Pro and I'm having the following issues.
The skirt and the brim print without issues using the 2nd extruder, but when it comes to printing the support. The extruder is floating in the air.
I've tried using Cura and Simplify3D and can't print the support.
Anyone know what the issue is?
Thank you!