Simplify3D User Forum

Hello,

I'm a new user of your software.

When i try to prepare a part for printing I import the part (doesnt need suports) then i clic on "Prepare to print" buton. But the result that i got is only 3 layers ...

Can you help me please to resolve this problem?

Thank you.

Have a look to tab ADVANCED, perhaps there is set a stop.

horst.w
GER

otherwise please attache a " *.factory " - file here.
To be create with tab FILE >>> Save Factory as ...

Thank you for your reply. Please find attached the .factory file.

Cant find any problems, is running fine for me.

Your settings are not optimized but that is not the problem .
Perhaps you have used the Cross Section View and the Z-height was limited.

H.