Page 1 of 1
Raise3D E2
Posted: Fri Jul 03, 2020 10:18 am
by Jbc
Any plans to add support for the Raise3D E2?
Re: Raise3D E2
Posted: Thu Jul 09, 2020 11:57 am
by S3D-Jake
Our profile development team can share a profile they're working on with you. Please send your request through this
link so we can quickly identify your request.
Re: Raise3D E2
Posted: Thu Aug 13, 2020 11:07 am
by DMP3D
Did you ever get a profile for the E2?
Re: Raise3D E2
Posted: Thu Aug 13, 2020 2:21 pm
by S3D-Mitch
Please use the contact us page, linked below, and we will be happy to send you the profile!
https://www.simplify3d.com/contact
Re: Raise3D E2
Posted: Sat May 21, 2022 10:48 pm
by blj1884
Getting close to getting the RAISE3D E2 Simplif3D FFF Profile Complete. I will upload it when done.
-Jason
Re: Raise3D E2
Posted: Wed Aug 31, 2022 6:55 am
by blj1884
Or you could use the configuration assistant If Simplify3D was not commenting fraud. Then again, Raise3D jumbled up the gcode for duplication and other features like Flashforge.
I sent that garbage printer back, but you can play around with the profiles I did create and or works in progress.