Simplify3D User Forum

Hi all, just got a FlashForge Creator Pro and thought I'd give S3D a go. Added the default profile but thinking it may have a couple of issues with dual nozzle prints.

Firstly it draws a line with each extruder thats half off the bed. Then near the start it seems to print a shadow of the print to the left of the model with the left extruder? Other than that, it seems fine and print continues. Is it just a bad profile? Has anyone got an updated version? I believe mine is the 2017 version.

The priming behavior you describe sounds correct but I am not sure about the 'shadow' you are describing. Could you post some screenshots and maybe a Factory File so we can take a look at this?