Delta Bed Leveling Calibration Request
Posted: Fri Oct 10, 2014 5:22 pm
Please add bed leveling/calibration for delta printers.
I find it (at least on my Orion) easiest to do the following steps on the printer's LCD panel itself:Jbc wrote:Please add bed leveling/calibration for delta printers.
- Home All Towers
- Incrementally bring Extruder down to bed
- Set New Z-Height
- Home Towers Again
- Run towers.gcode file
- Make Necessary adjustments to end-stop triggers
- Repeat
If your delta has an LCD, no need to level the bed via PC