Was unable to find an existing related thread. is there any support for connecting Simplify3D to 3DPrinterOS for network printing? If not, is there a way to connect Simplify3D to my Dremel 3d45 Idea Builder for network printing on a Mac - OS X?
Thanks,
Colton
-
coltonfisher
- Posts: 1
- Joined: Sat Aug 29, 2020 1:23 pm
Re: Looking for a way to link Simplify3D to 3DPrinterOS for networking printing.
Simplify3D doesn't support direct connections to 3DPrinterOS. I've documented your interest in this functionality being added for our development team to review.
"A bird does not sing because it has an answer. It sings because it has a song."
