Flashforge Creator 3 unalligned on x-axis after pausing print
Posted: Sun Nov 01, 2020 2:16 pm
Has anybody figured out yet what to adjust to avoid the print not being alligned after the print got paused?
I am not sure what to adjust for this.
BTW: This offset is 0.85 mm. This offset only happens when G code was made with S3D, this does not happen if using other slicers like Flashprint.
I am not sure what to adjust for this.
BTW: This offset is 0.85 mm. This offset only happens when G code was made with S3D, this does not happen if using other slicers like Flashprint.