Simplify3D User Forum

Posted: **Sun Nov 08, 2020 11:40 pm**

I have a Ender 3 Pro and I added a Self Leveling to it. I need to load the G Code that controls the self leveling. How do I do that? I did it in Cura and was pretty direct. Can't find the same type command in Simplify3D.
Thanks
Jay Beckham

Posted: **Fri Nov 13, 2020 4:52 pm**

add the gcode to your start script.

Posted: **Mon Dec 07, 2020 6:54 pm**

after
G28 Home all
add
G29 ABL

Simplify3D User Forum

G Code for Self Leveling Upgrade

G Code for Self Leveling Upgrade

Re: G Code for Self Leveling Upgrade

Re: G Code for Self Leveling Upgrade