Prusa i3 Mk3s Prusa PLA 0.4mm Miniature 32mm HELP =)
Posted: Fri Nov 27, 2020 9:28 am
Hello everyone I am new to 3d Printing and purchased a Prusa i3 MK3s. I have no trouble with larger prints with a 0.4mm nozzle but when it comes to Miniatures I am running into a bit of stringing, and very hard to remove supports.
I am printing miniatures from Loot-Studio they are 32mm in size. I have downloaded the config for the Prusa i3 Mk3s and modified a few settings any recommendation or feedback would be great.
I have looked at a number of videos and have tried a number of slicers from Cura, Prusa Slicer, MatterControl you name it and each print would get a little better result but Simplyfy 3d has made all my other prints look amazing so I am trying to pin down the best recommended settings.
Here are my settings
Much appreciate any help and thank you in advance. Any direction to any recommended resources or videos as well.
I am printing miniatures from Loot-Studio they are 32mm in size. I have downloaded the config for the Prusa i3 Mk3s and modified a few settings any recommendation or feedback would be great.
I have looked at a number of videos and have tried a number of slicers from Cura, Prusa Slicer, MatterControl you name it and each print would get a little better result but Simplyfy 3d has made all my other prints look amazing so I am trying to pin down the best recommended settings.
Here are my settings
Much appreciate any help and thank you in advance. Any direction to any recommended resources or videos as well.