Simplify3D User Forum

So I haven't changed any settings and this randomly started. No clue how to fix it im about to wipe everything.

It looks like you may be printing too far away from the build surface causing these loopy bits instead of a nice flat raft. This may be a settings issue or may be due to an issue with your bed probe. Can you please post a Factory File so we can look into this?

Sorry for the late reply, I will post the factory file later today for you. I can't get the hot end to print based on my z offsets it always goes to Z0 instead of Z0 -2.30 offset. But when I send G1 F60 Z0 through my octoprint console it goes where it should.

Here is my most recent attempt at printing a bed leveling square. I am going to replace my bltouch just to be sure.