Hi all.
I am new here.
Gear
Ender3
Swiss Micro Hotend.
3dTouch.
SKR Mini E3 v1.2, Ender 3
I installed a 3d touch on my ender 3.
I followed a guide https://www.reddit.com/r/ender3/comment ... 2_ender_3/ on redit and compiled my own firmware.
I flash the firmware and all is good.
I go to the menu and run bed leveling.
Leveling goes great and stops at the back right corner.
I use g29 in my gcode start script.
When the code is executed on my SKR Mini E3 v1.2, it auto homes in the center and then goes to the back right corner and proceeds to shoot out a bunch of filament in one spot.
I used big tree tech precompiled firmware and a few other precompiled firmware.
all do the same thing.
Has anyone seen this before ?
Thanks for any help
P.S if i try to print other slicer code from Cura, and Prusa I get the same thing.
