babj615
Posts: 1
Joined: Mon Dec 21, 2020 3:56 pm

FlashForge Creator Pro 2 Support?

Anyone using S3D with a FlashForge Creator Pro 2?

This model is not listed in the 'supported' products page, and since the last update was nearly 2 years ago....

Funny, the Software page still shows "Version 4.1 - Just Released!"
S3D-Jake
Posts: 1048
Joined: Wed Jun 20, 2018 12:45 pm

Re: FlashForge Creator Pro 2 Support?

Simplify3D's engineering team has a profile they can share with you via email. Contact support in order to get setup with the profile.
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “General Discussion and Tips”