FFCP OFFSET OLD TOPIC DOING MY HEAD
Posted: Sun Jan 03, 2021 11:39 am
Good afternoon all please forgive the question as it has been raised a number of times and I beleieve i have followed the links explicitly.. I have a FFCP using simplyfy 3d..
I never use dual colours in a sigle print but generally have two differing colours loaded to save changing filament all the time, my right nozzle starts in the centre of bed every time however the left always starts to the left
I have taken out the offset 34 tryed altering it on the machone and in the software but everytime it prints offset..
Please Please is there a simple fix
s I say have followed the links on previous posts perhaps Im missing something
I never use dual colours in a sigle print but generally have two differing colours loaded to save changing filament all the time, my right nozzle starts in the centre of bed every time however the left always starts to the left
I have taken out the offset 34 tryed altering it on the machone and in the software but everytime it prints offset..
Please Please is there a simple fix
s I say have followed the links on previous posts perhaps Im missing something