Simplify3D User Forum

Sorry in advance I come from CURA. I am trying to get a basic 8mm or so brim and since that isn't working very well there are gaps. I pushed it down till it was at the bed and couldn't find a sweet spot. Bed is Level...



Checked the Z-offset but still get



This causes the layers to pull away.

If I use Cura I don't see gaps in the layer I will post pics later confirming.

Is there some trick to brims?

When you post your addn prints later, please sort out the above prints...They're not showing.

Try adding files directly as attachments, and don't use links to photo sites ...or to the hard drive on your own PC.