How do I do brim?

[UKIan]

There's skirt and brim in the same section. I want a basic brim like you would get in Cura selecting Brim for adhesion type. Any ideas?

Cheers
ian

[jimc]

Just set the offset to zero then make the layers and perimeters whatever you want

[dennisjm]

That works pretty good but last I checked there is still a bug where a 0 offset doesn't actually touch the model on the first layer if the model has any parts that overhang.

Sooo.....

I've worked around this by saving off a .2mm square and circle that I sometimes just import and scale in the x/y direction until it's big enough to fit the model. Same thing as a brim but touches the model if you needed that.

[jimc]

Dennis, it doesnt do that anymore. 0 offset will touch the base iff the model all the way around

[UKIan]

Dennis, it doesnt do that anymore. 0 offset will touch the base iff the model all the way around

Hey, thanks, apologies for not replying sooner, I was (still am? tbc...) in noob mode where my posts are vetted and I forgot after a day