Raise3D Pro +
Posted: Mon Jun 07, 2021 2:31 am
Hello to everyone!
I have the problem that the presets for my printer no longer cover the entire print bed.
Although I have set the values for the X-axis in the "G-Code" card back to 305, it only prints on the X-axis from approx. 30mm upwards.
What could be the reason for this?
Best regards,
Enno
Printer Raise3D PRo plus
I have the problem that the presets for my printer no longer cover the entire print bed.
Although I have set the values for the X-axis in the "G-Code" card back to 305, it only prints on the X-axis from approx. 30mm upwards.
What could be the reason for this?
Best regards,
Enno
Printer Raise3D PRo plus