Page 1 of 1

Layer fan trouble starting even with "blip fan" enabled

Posted: Wed Jun 30, 2021 5:56 am
by Spawnreaper
I have a noctua 40x40x20 as a layer fan. I've set it up that on the first layer the fan is 0%, second 35%, 5th 60%.
Ive been having trouble that the fan tries to spin up on the second layer but doesn't have enough juice at 35% to get started. (you do see it nudge a little, if I help it a bit it does start)
So I turned the "blip fan to full power when increasing from idle" but that doesn't help.
Does anybody have any Idea how to tackle this?
any help would be greatly appreciated.