Posts: 1
Joined: Thu Jun 17, 2021 1:20 am

Questions about bridging?

Hello, I have been testing the bridge of Simplify 3D these days. I adjusted the "Unsupported area threshold" and Bridging extrusion multiplier parameters to make most of my bridges intact.

But the problem lies in the bridging edge. It seems that the bridging at the edge is extruded too much? As shown below:
I checked the relevant information on the forum, and I set the option to enable "Apply bridge settings to surroundings" in the slice.
But the problem still remains,
What should I do to make the bridge look better without support

Return to “Troubleshooting and Bug Reports”