bradleybell
Posts: 1
Joined: Sat Oct 30, 2021 10:16 pm

Automatic Support Generation

Hi,
When i click the checkmark for generate support and prepare the model to print. the support doesn't support some obvious overhangs for some reason. I wanted to print a character model and it did not even recognize that his hand had no support under it. I have compared it with mesh mixer and it is able to easily recognize that support is needed in that area. Any ideas on how to fix this?
Attachments
Inkedgenearet support bug_LI.jpg
S3D-Alex
Posts: 456
Joined: Thu Aug 30, 2018 1:23 pm

Re: Automatic Support Generation

Could you please post a Factory File so we can offer some specific advice for your situation? You can save this by going to File > Save Factory File As...

Return to “Troubleshooting and Bug Reports”