wirlybird
Posts: 1374
Joined: Sun Jul 17, 2016 1:32 pm

Perimeters Not Bonding.

S3D 4.12,
QIDI X-Max.
eSun PLA+
Temps - 215/65
Speed - 40mm/s base.
3 perimeters, 4 top/bottom.

Perimeters not bonding but it is only on two of the 4 sides. The other two sides are good.
I pulled them apart to test and see how much bonded.

Thanks for any ideas.
20211201_075539.jpg
User avatar
dkightley
Posts: 2405
Joined: Tue Mar 10, 2015 4:09 pm

Re: Perimeters Not Bonding.

Not knowing what its set at, I can't suggest what to increase it to.....but try increasing the outline overlap.

There again, looking at the gaps in the top surface, I'm wondering if your extrusion multiplier might need increasing......again, from and to, is anybody's guess!
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
wirlybird
Posts: 1374
Joined: Sun Jul 17, 2016 1:32 pm

Re: Perimeters Not Bonding.

Thanks and been a long time since I've been on here!

I'm leaning toward under extrusion myself.
S3D-Mitch
Posts: 25
Joined: Thu Jul 30, 2020 11:09 am

Re: Perimeters Not Bonding.

Usually when I have encountered non-symmetric behavior like the perimeter bonding issue in the pictures, it has been related to slop in one axis. Something like a pulley set screw working loose or even a belt that needs tightened. Hard to say if that is the case here, but may be worth a check.

Return to “Troubleshooting and Bug Reports”