Posts: 1
Joined: Thu Dec 02, 2021 2:35 pm

CreatBot F160

I just installed simplify3D and in the set up window, the drop down screen doesn't show my printer; CreatBot F160, but that printer is listed on the supported printer page in the support page. Where are the input items needed under "other" for this printer, or is there somewhere else to look to automatically install the correct driver? I see on the Creatbot web site the baud rate is 250000, and I have the build plate dimensions, but don't know the firmware to select. Cheers!
Posts: 1
Joined: Tue Mar 01, 2022 2:28 pm

Re: CreatBot F160

I found out that it is a RepRap Firmware thanks for finding the Baud Rate :D

Return to “General Discussion and Tips”