Vase mode - vary the extrusion width on the same layer
Posted: Tue Dec 07, 2021 2:24 am
Hi there,
I would like to print a cube in vase mode (with 0 top solid layers); green faces at 0.9mm extrusion width, and the blue one at 1.1mm extrusion width.
Is there any way to do this?
(The nozzle diameter is not an issue, I can print both wall thicknesses with the same nozzle.)
TIA
I would like to print a cube in vase mode (with 0 top solid layers); green faces at 0.9mm extrusion width, and the blue one at 1.1mm extrusion width.
Is there any way to do this?
(The nozzle diameter is not an issue, I can print both wall thicknesses with the same nozzle.)
TIA