Simplify3D User Forum

the web sites says my printer is supported, but i dont see it in the drop down list of printers.

the v3 is different in that it has a direct drive extruder.

if anyone can point me in the right direction or even better, has a profile they can share i would really appreciate it.

many thanks,

steve

I have an ender 5 and I think I could help if you don't have it working yet. It should not matter about direct drive as you should be still verifying that your retract is correct for you set up.. Bowden tube.. bigger number... Direct Drive .. smaller number. Not much else is different in the profile.