Simplify3D User Forum

Hi everyone,

I have purchased a Mosaic Palette 3 Pro: the hardware is very well designed, and it works rather reliably
However, the on-line slicer is quite poor, and its performances are improvable.

So, I am looking for alternatives. I know there is an add-on available for Prusa Slicer.

Is the Palette 3 Pro supported in Simplify3D ? (I've seen some discussions here around Palette 2).

Thanks in advance,

Anyone? I'm looking at getting one myself...

Hi.
Send this question directly to support, will get quicker answer.