likeke34
Posts: 2
Joined: Fri Jan 14, 2022 9:01 pm

Supports -Small Points Facing Downward

Any help would be greatly appreciated!

For the most part I have my printer dialed in with this software and have been getting amazing results but this one issue I can’t resolve.

Whenever I print something on supports, if the print starts off at a small point, it usually fails and gets lifted off the support, eventually. If it’s a flat or bigger surface on the supports it prints fine, it’s only when the print starts at a point/small surface area on top of my supports.

For example, imagine a few layers of supports on the bed and the start of the print is the bottom of a diamond. That small point at the bottom of the diamond eventually doesn’t stick and will get lifted off the supports

I’ll post my settings shortly
Edit: Sorry for the picture quality, here is my support settings. These support settings got supports to just pop off cleanly so I really like them

Sorry not quite sure how to post a picture here so I uploaded it to my Google drive and linked it
https://drive.google.com/file/d/10KCsr ... p=drivesdk
Image
Image

Return to “Troubleshooting and Bug Reports”