Thunderturtle
Posts: 1
Joined: Mon Feb 28, 2022 4:51 pm

Gaps in Brim

Having an issue with gaps in my brim. Can't figure out what's causing it.
Pics are attached
The nozzle diameter is correct on the extrusion menu.
I've tried both my 1.0 and 0.4mm nozzles with the same issue
Z gap is correct as you can see i'm getting nice wet-out.
I've 'reset' the profile in simplify back to the defaults but the problem persists.
I'm overlooking something. It has been fine since i started 8 months ago.
Creatbot F430

Thanks
Attachments
IMG_4948.JPG
IMG_4939.JPG

Return to “Troubleshooting and Bug Reports”