hi everyone
I'm taking a long print a part right now. but I did forget set the retraction setting. Can I send this setting to the printer in an ongoing printing process?
Assuming you're using standard retractions rather than firmware defined retractions, then no there would not be a way to update this during an ongoing build.
"A bird does not sing because it has an answer. It sings because it has a song."
S3D-Jake wrote: ↑Thu Mar 24, 2022 11:05 am
Assuming you're using standard retractions rather than firmware defined retractions, then no there would not be a way to update this during an ongoing build.