Top surface missing over infill
Posted: Wed Mar 23, 2022 4:21 pm
Hi
Seems like the final (horizontal surface has issue printing...When it is overhanging an infill (hexagon)
Anyone has lived that?
I searched and tried multiple settings modifications but no success...
Could it be the Internal Thina wall overlap? I just changed it to allow single extrusion fill from allow gap fill...witout exaclty knowiung the difference
IS it bridging???
I changed the extrusion from 203 to 199...
Thank you for helping
Regards
Nicolas
Seems like the final (horizontal surface has issue printing...When it is overhanging an infill (hexagon)
Anyone has lived that?
I searched and tried multiple settings modifications but no success...
Could it be the Internal Thina wall overlap? I just changed it to allow single extrusion fill from allow gap fill...witout exaclty knowiung the difference
IS it bridging???
I changed the extrusion from 203 to 199...
Thank you for helping
Regards
Nicolas