Simplify3D User Forum

I just upgraded to 4.1.2 on a Mac running Monterey 12.3.1, and my profile for FlashForge Creator Pro isn't being saved. It's hard to reproduce, but it seems like half the time when I add a new Process, the only profile available is "Default," and doesn't have much in the way of options. I then have to run the Configuration Assistant again, and sometimes it configures for the dual extruders and sometimes not. Never saw anything like this until the upgrade. Any thoughts? Thank you!

Vince

Same issue for me, I've resorted to File|Exporting FFF Profile whenever I make a change.
Then importing every time I start the App, pretty painful when dialling in a new printer.

MacBook Pro (16-inch, 2021) M1 Max.
Simplify3D Version: 4.1.2.

Is this the only place to raise this very annoying bug, so bad I'm looking at other slicers..