So OK right, all parts in the same process runs really fine. Part to part without double Layer
But how can I now order the parts?
It is not the name, not the order in models and not the startpoint!
If I write this I tested some ideas.
It is done: maybe helps some other people (right: islands sequentially must be on and only one process for all parts, more processes runs to, but only with change at the same layerhigh for all parts)
hope I can tell right!
the zero point is left and down X=horizontal Y=vertical
the highest position and highest partpoint in Y will print first (in my case it is top right)
the next highest position of the part is a little bit left and a little bit down (partsize doesn´t matter)
so on next 5 parts, they will print now in exactly order row from right to left
the next row parts must be exactly mirrored!
so the first part in the next row from the left side is the highest point of Part in Y
the second part must be a little bit right and alittle bit down and so on many many Parts
now the print runs in the second row from left to right and so on all parts very fine
if the last part and layer printing is done the printhead runs directly to the right upper par and starts the next layer
Thank you very much for your Help
now I understand the part order and this is now very easy