Page 1 of 1

Warping off the support

Posted: Sat May 07, 2022 6:24 am
by pivic
Hi All,

I use a Wanhao D4S with PLA. Settings Bed:55C, Left nozzle 230C.

The part is warping off the support :( I looked at the tips on how to stop the part from lifting off the bed, but I don't know what would cause it to separate from the support. The support is solidly attached to the bed.

Any help would be greatly appreciated.

Thanks,
simplify3d.png
Warp off support
Warp off support
Factorysettings .factory
Settings for the print
(121.48 KiB) Downloaded 80 times