With the smaller nozzle, do you still have the same drooping issue? I'm starting to suspect that an issue with our printer is an undersized cooling duct; it does an awful lot better with the .4 nozzle than the .8 nozzle on the other print head, even when the bridge speed is slow and the fan is 100%.Brochel27 wrote:... and then i switched to a 0.4mm nozzle for a finer print ...
Another side note. You don't need to make the entire outside "blue". That just indicates a certain group of print settings. Yellow bridges are totally fine, and show that the printer is doing something different for that. Green solid layers are fine if it's over good support, and it's good for checking extrusion.