HeinrichBe
Posts: 2
Joined: Sun Nov 15, 2020 10:53 am

Width of infill lines

I often have to print honeycombs of ceramic. At the moment I do some perimeter walls. And inside the form I use the infill feature "full honeycomb" to create the honeycomb structure. Using a standard stl of a honeycomb never works. S3D always tries to create ver ylittel boxes one by one. But with honeycomb infill it works nearly perfect. My question is: Is there a feature in S3D to make the lines of the infill smaller. At the end the width of these lines is teh thickness of my honeycomb walls.
S3D-Jake
Posts: 1052
Joined: Wed Jun 20, 2018 12:45 pm

Re: Width of infill lines

You can set the infill extrusion width % in the Infill tab.
"A bird does not sing because it has an answer. It sings because it has a song."
HeinrichBe
Posts: 2
Joined: Sun Nov 15, 2020 10:53 am

Re: Width of infill lines

Thanks it works great.

Return to “General Discussion and Tips”