Simplify3D User Forum

I have a FlashForge Pro DUAL (2 months old)
Sailfish v7.7
Mac OSX 10.9.5.latest

Might it be possible to load the SD Card over the USB connection?
Bit tired of constantly swapping the SD card in/out from printer to MPC ... something is going to break eventually ?!

Thank you,

you would never want to do that. it used to be an available option but was removed. its so slow to upload an sd card via usb its not even funny. i tried it once and a file that took 5 sec to write to sd normally took 20min to upload via usb. sd cards are meant to be removed and reinstalled over and over. if the card goes bad they are just a couple bucks.