Page 1 of 1
Wifi Connection
Posted: Wed Dec 14, 2022 2:17 pm
by Kiwi3D
Hi
I am trying to create a connection to a new VORON, using the Duet 6HC board. Default manual port 80. I am getting connection refused.
Any ideas
Cheers
Ray
Re: Wifi Connection
Posted: Thu Dec 15, 2022 4:56 pm
by Kiwi3D
Any feed back here S3D?
Im being patient
Re: Wifi Connection
Posted: Sat Dec 17, 2022 4:02 pm
by S3D-Jason
I don't think the Duet board was listed as one of the supported Wifi printers on the release notes, so I'm guessing there's just new code required to support that board. The team is very open to feature requests right now, so certainly vote for it on the Feature Request subforum if you want to see it added!
Re: Wifi Connection
Posted: Sat Dec 17, 2022 4:33 pm
by Kiwi3D
The connection is via a Raspberry Pi, so not direct to the Duet. That may have an impact of this I am guessing
Re: Wifi Connection
Posted: Sun Dec 18, 2022 6:27 pm
by irakly
Does not work for me either. I could not even get a configuration wizard to setup printer in a first place.