[FIXED] Simplify3D V5 no longer useable for RC airplane prints

[InspGadgt]

Here is the stl for the part I've been using for testing.

[wirlybird]

What is the sliced part supposed to look like? I did a check on the file and it has many errors and is 23 shells.

[wirlybird]

I've tried slicing in three slicers and get the same result in each.
Is there some specific settings they recommend?

[wirlybird]

I got it to slice in V4.1.2 but not in V5.

[jfkansas]

Yea! Got one thing fixed. I was looking at your model.
Here is something to try. Keep reducing the extrusion width, like 0.4 to 0.39 etc., and see if the parts show up at some point. this would indicate that the walls are very thin. Maybe it is a start.

I can try that but the models are designed for a specific line width of .42mm

Change minimum single extrusion width to 50% or lower.

[Mayk]

@ InspGadgt What Model is this? I have a lot 3dLabprint Models. Tried the B25 and it´s working, If you tell me what part makes the problems I can test it here.


Regards#


Mayk

[wirlybird]

Yea! Got one thing fixed. I was looking at your model.
Here is something to try. Keep reducing the extrusion width, like 0.4 to 0.39 etc., and see if the parts show up at some point. this would indicate that the walls are very thin. Maybe it is a start.

I can try that but the models are designed for a specific line width of .42mm

Change minimum single extrusion width to 50% or lower.

I tried it at 1% and it still doesn't slice correctly.

[InspGadgt]

What is the sliced part supposed to look like? I did a check on the file and it has many errors and is 23 shells.

This is what it looks like sliced in PrusaSlicer.

[InspGadgt]

I've tried slicing in three slicers and get the same result in each.
Is there some specific settings they recommend?

PrusaSlicer and Cura both can slice it properly with some settings adjustments.

https://3dlabprint.com/faq/prusaslicer/

https://3dlabprint.com/faq/cura/

[S3D-Jason]

Based on this thread, it sounds like it is still working correctly in V5:
viewtopic.php?t=16615