Page 1 of 1
Was hoping V5 would eliminate these short segments
Posted: Fri Dec 16, 2022 8:18 am
by zemlin
V4 does similar things. Was hoping it would go away in V5.
Re: Was hoping V5 would eliminate these short segments
Posted: Sat Dec 17, 2022 3:13 pm
by S3D-Jason
Can you post the factory file? I bet you could increase the Allowed Perimeter Overlap percentage by 10% and then all of those small segments would go away.
Re: Was hoping V5 would eliminate these short segments
Posted: Sat Dec 17, 2022 8:01 pm
by zemlin
I sent a factory file to support already. Changing the overlap moves them to different parts of the print, but doesn't eliminate the short perimeter loops.