Page 1 of 1
Set Middle Mouse Button For Default View?
Posted: Sat Dec 17, 2022 8:15 pm
by wirlybird
How can I map the middle mouse button so it will reset the default view when clicked like it does in V4?
Looked under keyboard shortcuts but it doesn't accept the mouse click as a valid "key".
Re: Set Middle Mouse Button For Default View?
Posted: Sun Dec 18, 2022 2:17 pm
by S3D-Jason
I believe the middle mouse button is now used for many of the 3D control schemes (Fusion 360, SolidWorks, etc). However, you can still use Ctrl+1 to return to the default view. Or you can customize that shortcut to any other key that you wish using the customizable shortcuts in V5.
Re: Set Middle Mouse Button For Default View?
Posted: Sun Dec 18, 2022 3:13 pm
by wirlybird
The middle mouse button was convenient. Now to have to hit a two key combo is a nuisance.
Even doing one key is not as good.
At least let us decide for ourselves what works best.
Re: Set Middle Mouse Button For Default View?
Posted: Mon Dec 19, 2022 5:47 am
by bolsoncerrado
wirlybird wrote: ↑Sun Dec 18, 2022 3:13 pm
At least let us decide for ourselves what works best.
THIS so much!