Simplify3D User Forum

Posted: **Mon Dec 19, 2022 4:48 am**

S3D v5

Whenever I doubleclick an STL/OBJ/.factory/.gcode (currently associated to S3D), S3D opens....but crashes with a Segmentation Fault 11.

If I open manually S3D then File->Open the files, it works fine.

I store Simplify3D folder INSIDE a folder which is INSIDE the Applications folder, if that helps troubleshooting.

Posted: **Mon Dec 19, 2022 9:39 am**

If you install the software in the default location (/Applications/Simplify3D-5.0.0), does the crash stop happening?

Posted: **Mon Dec 19, 2022 1:30 pm**

Why don't you as S3D try to install the app on a folder and let me know if it works? In the end you don't force the installation in a specific folder right?

Posted: **Tue Dec 20, 2022 12:45 am**

Looks like an un handled permission:

Posted: **Wed Dec 21, 2022 1:30 pm**

Further on this, on a Mac M1 with Ventura, when I doubleclick an STL, S3D opens and (finally!) stays open, but the STL is NOT loaded.

Simplify3D User Forum

Simplify3D Crashes when ran outside the Applications folder (macOS)

Simplify3D Crashes when ran outside the Applications folder (macOS)

Re: Simplify3D Crashes when ran outside the Applications folder (macOS)

Re: Simplify3D Crashes when ran outside the Applications folder (macOS)

Re: Simplify3D Crashes when ran outside the Applications folder (macOS)

Re: Simplify3D Crashes when ran outside the Applications folder (macOS)